- 32 analyses: each label kept, rewritten or removed by its analyst (section Requalification of the report; mm magnitudes where the targets have them) - SNCF01 x3, WILDSTRUBEL 2026-09-01 -> 2026-10-06 x3: verified from their existing labels under the new rules - long labels (no analysis): auto/analyses/long-labels/<STATION>/; NORDEND-169 and -195 run to 07/11, so NORDEND-283 and -284 (their continuation) are removed - reading-rules.md, stations.md: the citations of removed or rewritten labels point to their successor, or to [expert] Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
25 lines
4.7 KiB
Python
25 lines
4.7 KiB
Python
import json, sys
|
|
d = sys.argv[1]
|
|
B11 = ("From 13 to 16 October, the slow drift stops and goes back a little: the camera straightens slightly (tilt decreasing, rotation rising), and the same targets, COLJ19, POUI19, COLI20, COLI21, POUI20 and COLH20, partly come back in corr_x, POUI19 most of all; it turns on the afternoon of 16 October, when the drift resumes (labelled apart). "
|
|
"Cause according to the expert: parallax. Some targets are a few metres from the camera, others and the references several times farther; when the camera nods, its optical centre moves a little and the near targets shift more in the image than the far ones, while the compensation, a single image transformation fitted on the far references, treats all points as if they were at the same distance: the near targets are not fully corrected and seem to drift, the nearest the most. "
|
|
"This is seen on the image: COLJ19 and POUI19, which drift the most, have very large blurred spots, COLI20, COLI21 and POUI20 large spots with a halo, the mark of targets close to the camera, out of focus; the references, POUH21, which does not drift, and the bottom targets have small sharp spots. COLH20 drifts although its spot is small: for it, the reason is not established. "
|
|
"Their position in the image relative to each other hardly moves, their error_value stays stable. According to the expert, BREITHORN, MICHIGAN and NEBRASKA are in the same building: the cameras of MICHIGAN and NEBRASKA stop and move back on the same days; the return falls on days when the camera housing temperature no longer drops, link not established. "
|
|
"For the customer: this is not a movement of the structure but an artifact of the compensation on the near targets; the camera tilt is to be monitored.")
|
|
kept = []
|
|
for l in open(f"{d}/work/existing.jsonl"):
|
|
x = json.loads(l)
|
|
if x["id"] == "BREITHORN-11":
|
|
x = {"start": x["start"], "end": x["end"], "family": x["family"], "description": B11}
|
|
else:
|
|
x.pop("id")
|
|
kept.append(x)
|
|
new = [
|
|
{"start": "2026-10-13T20:00Z", "end": "2026-10-14T12:00Z", "family": "Displacement",
|
|
"description": "In the night of 13 to 14 October, over two measurements, the upper targets COLI20, COLJ19, POUI20 and POUI19 rise together clearly in corr_y, COLI20 also a little in corr_x; COLJ19 and COLI20 are still a little high at the morning measurement, then they are back at noon, POUI19 and COLJ19 only in part, staying a little higher with the slow return of the drift. The reference base shifts slightly against the targets (REFG44N and REFI'21 move apart in x), while the camera tilt takes a small step forward and comes back; the other targets hardly move. These four targets are among those close to the camera (large blurred spots on the image), which according to the expert the compensation corrects badly through parallax when the camera moves: a likely link with the tilt step, not established. According to the expert, BREITHORN, MICHIGAN and NEBRASKA are in the same building: the cameras of MICHIGAN and NEBRASKA take the same small forward tilt step at the same midnight measurement and partly come back at the next one, which points to a cause common to the building rather than to this camera alone. No rejection, no image shows anything in front of the targets (thumbnails of 20:00 and 00:00), the housing temperature stays almost flat over the night. Cause of the tilt step not established; the event falls inside the slow return of the camera drift labelled apart, but goes and comes back on its own dates. The immediate return says this is not a movement of the structure: points to ignore, nothing to do."},
|
|
{"start": "2026-10-14T04:00Z", "end": "2026-10-14T12:00Z", "family": "Obstruction",
|
|
"description": "For the duration of one measurement, on 14 October in the morning, several sensors deviate a little together, then return at the next measurement: the reference REFPOU22 rises in corr_y while the references REFG44N and REFI'21 go down, COLH20 and POUI20 rise in corr_x, COLI21 goes down; the error_value of REFG44N and COLH20 rises a little, nothing is rejected, and the camera scale dips for that measurement only, the housing temperature being flat. On the image of 08:00, lit objects (a vehicle or machine, absent at 04:00 and 12:00) appear at the bottom of the scene, behind the references REFI'21, REFH22, REFPOU22 and the bottom targets COLI21, COLI22, POUI24, changing the background around their spots, which stay visible. Seen on the image: the lit background of a passage disturbs the references slightly and the base moves all the targets together. This is not a movement: point to ignore."},
|
|
]
|
|
with open(f"{d}/labels.jsonl", "w") as f:
|
|
for x in sorted(kept + new, key=lambda x: (x["start"], x["end"])):
|
|
f.write(json.dumps(x, ensure_ascii=False) + "\n")
|